Grooved pins. Half-length centre grooved1 Scope This International Standard specifies the characteristics of half length centre grooved pins made of steel or austenitic stainless steel which have three equally spaced grooves impressed longitudinally on their exterior surface, with nominal diameter, d1, from 1,5 mm to 25 mm inclusive. The displaced material to each side of the grooves forming an expanded diameter, d2, which is larger than the nominal diameter d1 will cause a non positive

unarmoured cables removed and the range of multicore auxiliary cables extended to include up to 48 cores

Why should you use BS EN 1097‑2

test and measurement

Why should you use ISO 10551-Ergonomics of the physical environment

This not only enables you to check that the connection works correctly

cyclic fatigue

The test systems specified are intended for use only in small steam sterilizers Type B conforming to prEN 13060-2 and having a usable chamber space greater than 10 l and for small steam sterilizers Type S conforming to prEN 13060-4 also having a usable chamber space greater than 5 l

This part of IEC 62021 describes two procedures for the determination of the acidity of unused and used electrical non-mineral insulating oils

Other aspects addressed in BS 7669-3 include:

evaluation process

What is BS EN 13422 - Portable deformable warning devices and delineators about

patient end