Mopeds. Measurement methods for location of centre of gravity1 Scope This International Standard specifies a measuring method for determining the location of the centre of gravity of the moped and of the moped rider combination. It applies to two wheeled mopeds. Other measuring methods can be used if it is demonstrated that the results are equivalent. The measuring results obtained by the method given in this International Standard alone (see Annex A) cannot be used for an evaluation of the vehicle stability

BS EN 61119-2 discusses general requirements

2 guidelines ensures efficiency and quality assurance for its users

and methods for measuring the capacitance variation in a cable

the type of floor covering used and the installation of both

If the symbol validation process detailed in BS ISO 15223-2 has been complied with

Semi-automatic strapping machines

enabling users to accurately determine the travel speed of agricultural wheeled tractors

Machines conforming to this standard are suitable for other uses

The strength grade marking requirement in BS 4439 is only mandatory for steel screwed studs of 12 mm diameter and larger manufactured to strength grade designation 8

and manual handling of bottles

It also includes a further dynamic method that uses a wide-band input signal

PAS 3002 presents five key principles to form the basis of an organization’s approach: